TCT: Essentium CEO Discusses the Company’s Efforts in Promoting 3D Printing as More Than Just a Prototyping Tool May 4, 2020May 5, 2020 | The Essentium Team Share Essentium CEO Blake Teipel was interviewed by TCT Magazine about how additive manufacturing can be beneficial to manufacturing to enhance mass production in addition to the standard prototyping process. By installing 3D printing equipment that is ‘highly flexible’, manufacturers can begin to defray some supply chain risks, perhaps by allowing parts to be produced locally, or by printing jigs, fixtures and tooling to keep factories operating at the scales they’re used to without prolonged lead times. Read more: TCT Magazine Share
Essentium CEO Blake Teipel was interviewed by TCT Magazine about how additive manufacturing can be beneficial to manufacturing to enhance mass production in addition to the standard prototyping process. By installing 3D printing equipment that is ‘highly flexible’, manufacturers can begin to defray some supply chain risks, perhaps by allowing parts to be produced locally, or by printing jigs, fixtures and tooling to keep factories operating at the scales they’re used to without prolonged lead times. Read more: TCT Magazine
The Essentium Team November 23, 2020 Forbes: A Look How This Texas Startup Is Helping The Air Force Use 3D Printing To Replace Parts A Texas-based startup with $22.1 M in funding helps the U.S. Air Force 3D print replacement parts. Elisa Teipel, Ph.D., Chief Development Officer and Co-founder of Essentium said that more than 10,000 replacement part requests are delayed or unfilled each year despite a willingness to pay premium prices. Read More
The Essentium Team November 23, 2020 Additive Manufacturing: 3 Design Techniques for High Speed Extrusion 3D Printing “High Speed Extrusion” (HSE) is Essentium’s rapid deposition process for 3D printing polymer parts at production speeds. It is fused filament fabrication (FFF), but the speed means even the design considerations appropriate to FFF may not be sufficient for this process. Tom Mulholland describes the design considerations for HSE. Read More
The Essentium Team November 22, 2020 Manufacturing Tomorrow: 3D Printing Will Soon Be a Game-Changer in the Manufacturing Industry – Here’s Why Until now, manufacturers have been dipping their toes and getting familiar with AM technology, using it to create prototypes rather than final products. But that is changing. It’s only a matter of time before AM makes the leap from prototyping to manufacturing on the factory floor. And this leap will happen a lot sooner than most people think. Read More
